The ET120 and ET60 Audio Frequency Induction Loop amplifiers have been designed to meet the requirements of buildings to comply with the DDA and building regulations document M, or anywhere where provision is allowed for hard of hearing clients.

The unit is self-contained in a wall mount enclosure with an attractive ABS lid and metal back box, which has 20mm gland knockouts on the top for signal cables and the bottom for mains connection allowing simple cable management & installation.

Both models feature metal loss correction, which restores the high frequencies removed by metal in buildings such as ceiling grids and floor reinforcing.

The ET120 covers a square area of 120m², (11m a side) and rectangular areas up to 70m by 5m (350m²) such as corridors (see chart later), whilst the ET60 Covers a square room of 64m², (8m a side) and rectangular areas up to 55m by 3m (165m²)

Front panel indication is given for input signal limit and peak loop drive current.

At A Glance

• Balanced or Unbalanced Microphone input

• Line or 100v Line input

• 120m² square area coverage (64m² for the ET60)

• Covers areas up to 70m x 5m (350m²)

• Studio Quality Compressor Limiter

• Wall Mounted for permanent fixture

• Metal Loss Correction

• Secure mix controls on front

• 4A Peak Current (3A ET60)

• >8A short Term Peak Current

• Phantom Power on the microphone input

• Two part Screw terminals for ease of installation.